Telit Wireless Solutions LE910 - Page 334

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 334 of 509
Mod. 0808 2011-07 Rev.2
indication format when the socket is closed as follows
0 – NO CARRIER
(default)
Indication is sent as usual, without additional information
1 – NO CARRIER:<connId>
Indication of current <connId> socket connection identifier
is added
2 – NO CARRIER:<connId>,<cause>
Indication of current <connId> socket connection identifier
and closure <cause> are added
For possible <cause> values, see also #SLASTCLOSURE
Note: like #SLASTCLOSURE, in case of subsequent consecutive
closure causes are received, the original disconnection cause
is indicated.
Note: in the case of command mode connection and remote closure
with subsequent inactivity timeout closure without retrieval of all
available data(#SRECV or SRING mode 2), it is indicated
cause 1 for both possible FIN and RST from remote.
AT#SCFGEXT2?
Read command returns the current socket extended configuration
parameters values for all the six sockets, in the format:
#SCFGEXT2:<connId1>,<bufferStart1>,0,0,0,0<CR><LF>
. . .
#SCFGEXT2:<connId6>,<bufferStart6>,0,0,0,0<CR><LF>
AT#SCFGEXT2=?
Test command returns the range of supported values for all the
subparameters.
Example
AT#SCFGEXT2=1,1
OK
AT#SCFGEXT2=2,1
OK
AT#SCFGEXT2?
#SCFGEXT2: 1,1,0,0,0,0
#SCFGEXT2: 2,1,0,0,0,0
#SCFGEXT2: 3,0,0,0,0,0
#SCFGEXT2: 4,0,0,0,0,0
#SCFGEXT2: 5,0,0,0,0,0