Telit Wireless Solutions LE910 - Page 293

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 293 of 509
Mod. 0808 2011-07 Rev.2
#SMSATRUN – Enable SMS AT Run service
SELINT 2
Note1: When the service is active on a specific AT instance (see
AT#SMSATRUNCFG), that instance cannot be used for any other scope, except
for OTA service that has the highest priority.
For example in the multiplexer request to establish the Instance, the request will
be rejected.
Note2: the current settings are stored in NVM.
AT#SMSATRUN?
Read command returns the current settings of <mode> and the value of <stat> in
the format:
# SMSATRUN: <mod>,<stat>
where:
<stat> - service status
0 – not active
1 - active
AT#SMSATRUN =?
Test command returns the supported values for the SMSATRUN parameters
Notes:
• By default the SMS ATRUN service is disabled
It can be activated by the command AT#SMSATRUN.