Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 162 of 509
Mod. 0808 2011-07 Rev.2
+CMMS – More Message to Send
Set command controls the continuity of SMS relay protocol link. When feature is
enabled (and supported by network) multiple messages can be sent much faster as
link is kept open.
Parameter:
<n>
0 - disable (factory default)
1 - keep enabled until the time between the response of the latest message send
command (+CMGS, +CMSS, etc.) and the next send command exceeds 5
seconds, then the link is closed and the parameter <n>
is automatically reset to
0
2 - enable (if the time between the response of the latest message send command
and the next send command exceeds 5 seconds, the link is closed but the
parameter <n> remains set to 2)
Read command reports the current value of the parameter <n> in the format:
+CMMS: <n>
Test command returns the range of supported <n>
To Next Page
Loading...
Need help?
General
