Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 165 of 509
Mod. 0808 2011-07 Rev.2
+CNMI - New Message Indications To Terminal Equipment
<dcs> - Data Coding Scheme
<pag> - page number
<pags> - total number of pages of the message
<data> - CBM Content of Message
• If <dcs> indicates that GSM03.38 default alphabet is used , each
character of GSM alphabet will be converted into current TE character
set (see +CSCS)
• If <dcs> indicates that 8-bit or UCS2 data coding scheme is used, each
8-bit octet will be converted into two IRA character long hexadecimal
number (e.g. octet 0x2A will be converted as two characters 0x32 0x41)
<ds> - SMS-STATUS-REPORTs reporting option
0 - status report receiving is not reported to the DTE and is not stored
1 - the status report is sent to the DTE with the following unsolicited result code:
(PDU Mode)
+CDS: <le
ngt
h><CR><LF><PDU>
where:
<length> - PDU length
<PDU> - message PDU
(TEXT Mode)
+CDS: <fo>,<mr>,<ra>,<tora>,<scts>,<dt>,<st>
where:
<fo> - first octet of the message PDU
<mr> - message reference number; 3GPP TS 23.040 TP-Message-
Reference in integer format
<ra> - recipient address, string type, represented in the currently selected
character set (see +CSCS)
<tora> - type of number <ra>
<scts> - arrival time of the message to the SC
<dt> - sending time of the message
<st> - message status as coded in the PDU
2 - if a status report is stored, then the following unsolicited result code is sent:
+CDSI: <memr>,<index>
where:
<memr> - memory storage where the new message is stored
"SM"
<index> - location on the memory where SMS is stored
<bfr> - buffered result codes handling method:
0 - TA
buffer of unsolicited result codes defined within this command is flushed to
the TE when <mode>=1..3 is entered (OK response shall be given before
To Next Page
Loading...
Need help?
General
