Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 194 of 509
Mod. 0808 2011-07 Rev.2
#CEER – Extended numeric error report
Interworking, unspecified
Unsuccessful attach cause NO SERVICE
Unsuccessful attach cause NO ACCESS
Unsuccessful attach cause GPRS SERVICE REFUSED
PDP deactivation requested by NWK
PDP deactivation cause LLC link activation Failed
PDP deactivation cause NWK reactivation with same TI
PDP deactivation cause GMM abort
PDP deactivation cause LLC or SNDCP failure
PDP unsuccessful activation cause GMM error
PDP unsuccessful activation cause NWK reject
PDP unsuccessful activation cause NO NSAPI available
PDP unsuccessful activation cause SM refuse
PDP unsuccessful activation cause MMI ignore
PDP unsuccessful activation cause Nb Max Session Reach
PDP unsuccessful activation cause wrong APN
PDP unsuccessful activation cause unknown PDP address or
type
PDP unsuccessful activation cause service not supported
PDP unsuccessful activation cause QOS not accepted
PDP unsuccessful activation cause socket error
FDN is active and number is not in FDN
Call operation not allowed
Call barring on outgoing calls
Call barring on incoming calls
Test command returns OK result code.
To Next Page
Loading...
Need help?
General
