Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 216 of 509
Mod. 0808 2011-07 Rev.2
0..6 - it is the ordinal number of the cell, in the neighbour list of the serving cell
(default 0, serving cell).
7 - it is a special request to obtain GSM-related information from the whole set of
seven cells in the neighbour list of the serving cell.
(UMTS network)
0 – it is the serving cell in idle; Active set cells are also reported in CELL_DCH
state, i.e. during a call (default)
1 – it is the candidate set ( cells that belong to the Active set, only reported in
CELL_DCH state, i.e. during a call)
2 – it is the synchronized neighbour set (cells that belong to the Virtual Active set,
only reported in CELL_DCH state, i.e. during a call)
3 – it is the asynchronized neighbour set
(cells which are not suitable cells to camp
on)
4 – it is the ranked neighbour set (cells which are suitable cells to camp on)
7 - it is a special request to obtain information from the whole set of detected cells
in the neighbour list of the serving cell.
5..6 – it is not available
Execution command (AT#MONI<CR>) reports GSM/UMTS-related information
for selected cell and dedicated channel (if exists).
3. If the last setting done by #MONI is in the range [0..6], the output format is as
follows:
d) When extracting data for the serving cell and the network name is known the
format is:
(GSM network)
#MONI: <netname> BSIC:<bsic> RxQual:<qual> LAC:<lac> Id:<id>
ARFCN:<arfcn> PWR:<dBm> dBm TA: <timadv>
(UMTS network)
#MONI: <netname> PSC:<psc> RSCP:<rscp> LAC:<lac>
Id:<id>EcIo:<ecio> UARFCN:<uarfcn> PWR:<dBm> dBm DRX:<drx>
SCR:<scr>
e) When the network name is unknown, the format is:
(GSM network)
#MONI: <cc> <nc> BSIC:<bsic> RxQual:<qual> LAC:<lac> Id:<id>
ARFCN:<arfcn> PWR:<dBm> dBm TA: <timadv>
(UMTS network)
#MONI: <cc> <nc> PSC:<psc> RSCP:<rscp> LAC:,<lac> Id:<id>
EcIo:<ecio> UARFCN:<uarfcn> PWR:<dBm> dBm DRX:<drx>SCR:<scr>
f) When extracting data for an adjacent cell (or active set cell), the format is:
To Next Page
Loading...
Need help?
General
