Telit Wireless Solutions LE910 - Page 349

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 349 of 509
Mod. 0808 2011-07 Rev.2
AT#SSENDUDP=?
Test command reports the supported range of values for parameters
<connId>,<remoteIP> and <remotePort>
Example
Starts listening on <LocPort>(previous setting of firewall through #FRWL has
to be done)
AT#SLUDP=1,1,<LocPort>
OK
SRING: 1 // UDP data from a remote host available
AT#SA=1,1
OK
SRING: 1
AT#SI=1
#SI: 1,0,0,23,0 // 23 bytes to read
OK
AT#SRECV=1,23
#SRECV:1,23
message from first host
OK
AT#SS=1
#SS: 1,2,<LocIP>,<LocPort>,<RemIP1>,<RemPort1>
OK
AT#SSENDUDP=1,<RemIP1>,<RemPort1>
>response to first host
OK
SRING: 1 // UDP data from a remote host available
AT#SI=1
#SI: 1,22,23,24,0 // 24 bytes to read
OK
AT#SRECV=1,24
#SRECV:1,24
message from second host
OK