Telit Wireless Solutions LE910 - Page 383

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 383 of 509
Mod. 0808 2011-07 Rev.2
#FTPRECV – Receive Data In Command Mode
SELINT 2
Example
AT#FTPRECV?
#FTPRECV: 3000
OK
Read required part of the buffered data:
AT#FTPRECV=400
#FTPRECV: 400
Text row number 1 * 1111111111111111111111111 *
Text row number 2 * 2222222222222222222222222 *
Text row number 3 * 3333333333333333333333333 *
Text row number 4 * 4444444444444444444444444 *
Text row number 5 * 5555555555555555555555555 *
Text row number 6 * 6666666666666666666666666 *
Text row number 7 * 7777777777777777777777777 *
Text row number 8 * 88888888888888888888
OK
AT#FTPRECV =200
#FTPRECV: 200
88888 *
Text row number 9 * 9999999999999999999999999 *
Text row number 10 * AAAAAAAAAAAAAAAAAAAAAAAAA *
Text row number 12 * BBBBBBBBBBBBBBBBBBBBBBBBB *
Text row number 13 * CCCCCCCCCCCCCCCC
OK
Note: to check when you have received complete file it’s possible to use
AT#FTPGETPKT read command:
AT#FTPGETPKT?
#FTPGETPKT: sample.txt,0,1
OK
(you will get <eof> set to 1)