Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 440 of 509
Mod. 0808 2011-07 Rev.2
#STGI - SIM Tookit Get Information
0
bit 8:
0 - no help information available
1 - help information available
<numOfItems> - number of items in the list
<titleText> - string giving menu title
<itemId> - item identifier
1..<numOfItems>
<itemText> - title of item
<nextActionId> - the next proactive command type to be issued upon execution of
the menu item.
0 - no next action information available.
Note: upon receiving the #STGI response, the TA must send #STSR command (see
below) to confirm the execution of the proactive command and provide any
required user response, e.g. selected menu item.
The read command can be used to request the currently ongoing proactive
command and the SAT state in the format
#STGI: <state>,cmdType>
where:
<state> - SAT interface state (see #STIA)
<cmdType> - ongoing proactive command
An error message will be returned if there is no pending command.
Test command returns the range for the parameters <state> and <cmdType>.
The unsolicited notification sent to the user:
#STN: 37
is an indication that the main menu of the SIM Application has been sent to the TA.
It will be stored by the TA so that it can be displayed later at any time by issuing an
AT#STGI=37 command.
A typical SAT session on AT interface starts after an #STN: 37 unsolicited code is
received, if enabled. At that point usually an AT#STGI=37 command is issued, and
after the SAT main menu has been displayed on TE an AT#STSR=37,0,x
command is issued to select an item in the menu (see below). The session usually
ends with a SIM action like sending an SMS, or starting a call. After this, to restart
the session from the beginning going back to SAT main menu it is usually required
an AT#STSR=37,16 command.
The unsolicited notification sent to the user:
To Next Page
Loading...
Need help?
General
