Telit Wireless Solutions LE910 - Page 463

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 463 of 509
Mod. 0808 2011-07 Rev.2
#SHSAGC - Handset Automatic Gain Control
SELINT 2
AT#SHSAGC?
Read command reports whether the automatic gain control function on audio
handset input is currently enabled or not, in the format:
#SHSAGC: <mode>
AT#SHSAGC =?
Test command returns the supported range of values of parameter
<mode>.