Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 83 of 509
Mod. 0808 2011-07 Rev.2
<status> represents the status of the service:
0 - inactive
1 - active
<classn> - same as <class>
Note: the unsolicited result code enabled by parameter <n> is in the format::
+CCWA: <number>,<type>,<class>,[<alpha>][,<cli_validity>]
where:
<number> - string type phone number of calling address in format specified by
<type>
<type> - type of address in integer format
<class> - see before
<alpha> - string type; alphanumeric representation of <number> corresponding to
the entry found in phonebook; used character set should be the one
selected with +CSCS.
<cli_validity>
0 - CLI valid
1 - CLI has been withheld by the originator
2 - CLI is not available due to interworking problems or limitations of originating
network
Note: if parameter <cmd> is omitted then network is not interrogated.
Note: in the query command the class parameter must not be issued.
Note: the difference between call waiting report disabling (AT+CCWA = 0,1,7)
and call waiting service disabling (AT+CCWA = 0,0,7) is that in the first case the
call waiting indication is sent to the device by network but this last one does not
report it to the DTE; instead in the second case the call waiting indication is not
generated by the network. Hence the device results busy to the third party in the
2
nd
case while in the 1
st
case a ringing indication is sent to the third party.
Note: The command AT+CCWA=1,0 has no effect a non sense and must not be
Read command reports the current value of the parameter <n>.
Test command reports the supported values for the parameter <n>.
To Next Page
Loading...
Need help?
General
