Allied Telesis AT-9000 Series - Page 1212

Chapter 73: RMON
1212
Phase 2: Adding the RMON Statistics Group to the Port
The steps here add a statistics group to port 20 so that the port statistics
are collected by the switch for use with RMON.
awplus(config)# snmp-server host 149.211.243.12
traps version 2c Station12ap
awplus(config)# snmp-server host 149.211.243.75
traps version 2c Station12ap
Add the IP addresses of the trap
receivers to the community string
with the SNMP-SERVER HOST
command.
awplus(config)# exit
Return to the Privileged Exec
mode.
awplus# show snmp-server
Verify that SNMP is enabled on
the switch with the SHOW SNMP-
SERVER command.
awplus# show snmp-server community
Verify the new community string
with the SHOW SNMP-SERVER
COMMUNITY command.
awplus# show running-config
Verify the host IP addresses of the
community string with the SHOW
RUNNING-CONFIG command.
awplus# configure terminal
Enter the Global Configuration
mode.
awplus(config)# interface port1.0.20
Enter the Port Interface mode for
port 20.
awplus(config-if)# rmon collection stats 20
Add a statistics group to the port
with the RMON COLLECTION
STATS command. The groups are
easier to remember when their ID
numbers are the same as the port
numbers.
awplus(config-if)# end
Return to the Privileged Exec
mode.
awplus# show rmon statistics
Use the SHOW RMON
STATISTICS command to verify
the configuration of the new group.