Allied Telesis AT-9000 Series - Page 1213

AT-9000 Switch Command Line User’s Guide
1213
Phase 3: Creating the Event
The event in this example is to send an SNMP trap and to log a message
in the event log. The event is assigned the ID number 2.
Phase 4: Creating the Alarm
Here are the specifications of the alarm:
 Alarm ID number 2
 Monitored statistic: etherStatsBroadcastPkts - OID
1.3.6.1.2.1.16.1.1.1.6 (broadcast packets)
 Statistics group ID number: 20
 Interval: 60 seconds
 Rising threshold: 10000 packets
 Rising threshold event: 2
 Falling threshold: 1000 packets
 Falling threshold event: 2
Here are the steps to creating the alarm.
awplus# configure terminal
Enter the Global Configuration
mode.
awplus(config)# rmon event 2 log trap Station12ap
description trap_and_log_event
Create the event with the RMON
EVENT LOG TRAP command. It
is important to remember that the
community string is case sensitive.
awplus(config)# exit
Return to the Privileged Exec
mode.
awplus# show rmon event
Use the SHOW RMON EVENT
command to verify the
configuration of the new event.
awplus# configure terminal
Enter the Global Configuration
mode.
awplus(config)# rmon alarm 2
1.3.6.1.2.1.16.1.1.1.6.20 interval 60 delta
rising-threshold 10000 event 2 falling-threshold
1000 event 2
Create the alarm with the RMON
ALARM command.
awplus(config)# exit
Return to the Privileged Exec
mode.