Cisco Catalyst 3650 Series User Manual

show errdisable recovery
To display the error-disabled recovery timer information, use the show errdisable recovery command in
EXEC mode.
show errdisable recovery
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
User EXEC
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
A gbic-invalid error-disable reason refers to an invalid small form-factor pluggable (SFP) module interface.
Though visible in the output, the unicast-flood field is not valid.Note
Examples
This is an example of output from the show errdisable recovery command:
Device> show errdisable recovery
ErrDisable Reason Timer Status
----------------- --------------
udld Disabled
bpduguard Disabled
security-violatio Disabled
channel-misconfig Disabled
vmps Disabled
pagp-flap Disabled
dtp-flap Disabled
link-flap Enabled
l2ptguard Disabled
psecure-violation Disabled
gbic-invalid Disabled
dhcp-rate-limit Disabled
unicast-flood Disabled
storm-control Disabled
arp-inspection Disabled
loopback Disabled
Timer interval:300 seconds
Interfaces that will be enabled at the next timeout:
Interface Errdisable reason Time left(sec)
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
75
show errdisable recovery

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)