Cisco Catalyst 3650 Series User Manual

well-known group CISCO-RP-ANNOUNCE (224.0.1.39). This message announces the router as a candidate
RP for the groups in the range described by the access list.
Examples
The following example shows how to configure the switch to send RP announcements out all Protocol
Independent Multicast (PIM)-enabled interfaces for a maximum of 31 hops. The IP address by which the
switch wants to be identified as RP is the IP address associated with Gigabit Ethernet interface 1/0/1 at an
interval of 120 seconds:
Device(config)# ip pim send-rp-announce GigabitEthernet1/0/1 scope 31 group-list 5 interval
120
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
238
ip pim send-rp-announce

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)