mac address-table move update
To enable the MAC address table move update feature, use the mac address-table move update command
in global configuration mode on the switch stack or on a standalone switch. To return to the default setting,
use the no form of this command.
mac address-table move update {receive | transmit}
no mac address-table move update {receive | transmit}
Syntax Description
Specifies that the switch processes MAC address-table move update messages.receive
Specifies that the switch sends MAC address-table move update messages to other
switches in the network if the primary link goes down and the standby link comes
up.
transmit
Command Default
By default, the MAC address-table move update feature is disabled.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
The MAC address-table move update feature allows the switch to provide rapid bidirectional convergence if
a primary (forwarding) link goes down and the standby link begins forwarding traffic.
You can configure the access switch to send the MAC address-table move update messages if the primary
link goes down and the standby link comes up. You can configure the uplink switches to receive and process
the MAC address-table move update messages.
Examples
This example shows how to configure an access switch to send MAC address-table move update messages:
Device# configure terminal
Device(config)# mac address-table move update transmit
Device(config)# end
This example shows how to configure an uplink switch to get and process MAC address-table move update
messages:
Device# configure terminal
Device(config)# mac address-table move update receive
Device(config)# end
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
930
mac address-table move update
To Next Page
Loading...
Need help?
General
