Cisco Catalyst 3650 Series

net-debug
To display or change the network debug values use the net-debug command in rommon mode.
net-debug [new-value]
Syntax Description
(Optional) New debug value to use.
new-value
Command Modes
Rommon
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Everest 16.5.1
Usage Guidelines
This command enables or disables log levels for each of the following functional areas:
•
Domain Name System (DNS)
•
Dynamic Host Control Protocol (DHCP)
•
File Transfer Protocol (FTP)
•
Hypertext Transfer Protocol (HTTP)
•
IP
•
TCP
•
UDP
•
Uniform Resource Identifier (URI)
Examples
This following is sample output from the net-debug command:
Device: net-debug
ether: 0
ip: 0
dhcp: 0
udp: 0
tcp: 0
http: 0
dns: 0
uri: 0
t/ftp: 2
ip6: 0
dhcp6: 0:000 200 000 000
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
586
net-debug