Cisco Catalyst 3650 Series User Manual

clear l2protocol-tunnel counters
To clear the protocol counters in protocol tunnel ports, use the clear l2protocol-tunnel counters command
in privileged EXEC mode.
clear l2protocol-tunnel counters [interface-id]
Syntax Description
(Optional) The interface (physical interface or port channel)
for which protocol counters are to be cleared.
interface-id
Command Default
None
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
Use this command to clear protocol tunnel counters on the switch or on the specified interface.
Examples
This example shows how to clear Layer 2 protocol tunnel counters on an interface:
Device# clear l2protocol-tunnel counters gigabitethernet1/0/3
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
1005
clear l2protocol-tunnel counters

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)