EasyManua.ls Logo

Cisco Catalyst 3650 Series

Cisco Catalyst 3650 Series
1108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
show platform hardware fed switch forward
To display device-specific hardware information, use the show platform hardware fed switch switch_number
command.
This topic elaborates only the forwarding-specific options, that is, the options available with the show platform
hardware fed switch {switch_num | active | standby } forward summary command.
The output of the show platform hardware fed switch switch_number forward summary displays all the
details about the forwarding decision taken for the packet.
show platform hardware fed switch {switch_num| active| standby} forward summary
Syntax Description
The switch for which you want to display information. You have the
following options :
switch_numID of the switch.
activeDisplays information relating to the active switch.
standbyDisplays information relating to the standby switch, if
available.
switch {switch_num | active |
standby }
Displays packet forwarding information.forward summary
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Denali 16.3.1
Usage Guidelines
Do not use this command unless a technical support representative asks you to. Use this command only when
you are working directly with a technical support representative while troubleshooting a problem.
Fields displayed in the command output are explained below.
Station Index : The Station Index is the result of the layer 2 lookup and points to a station descriptor
which provides the following:
Destination Index : Determines the egress port(s) to which the packets should be sent to. Global
Port Number(GPN) can be used as the destination index. A destination index with15 down to 12
bits set indicates the GPN to be used. For example, destination index - 0xF04E corresponds to
GPN - 78 (0x4e).
Rewrite Index : Determines what needs to be done with the packets. For layer 2 switching, this is
typically a bridging action
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
98
show platform hardware fed switch forward

Table of Contents

Other manuals for Cisco Catalyst 3650 Series

Related product manuals