service-list mdns-sd
To enter mDNS service discovery service-list mode on the device, use the service-list mdns-sd command.
To exit mDNS service discovery service-list mode, use the no form of the command.
service-list mdns-sd service-list-name {permit | deny} sequence-number [query]
no service-list mdns-sd service-list-name {permit | deny} sequence-number [query]
Syntax Description
Name of the service list.
service-list-name
Permits a filter on the service list
to be applied to the sequence
number.
permit sequence number
Denies a filter on the service list to
be applied to the sequence number.
deny sequence number
Associates a query for the service
list name.
query
Command Default
Disabled.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
Service filters are modeled around access lists and route maps.
Multiple service maps of the same name with different sequence numbers can be created and the evaluation
of the filters will be ordered on the sequence number. Service lists are an ordered sequence of individual
statements, each has a permit or deny result. Evaluation of a service list consists of a list scan, in a predetermined
order, and an evaluation of the criteria of each statement that matches. A list scan is aborted once the first
statement match is found and an action, permit or deny associated with the statement match is performed.
Default action after scanning through the entire list will be to deny.
This command can be used to enter mDNS service discovery service-list mode.
In this mode you can:
•
Create a service list and apply a filter on the service list according to the permit or deny option applied
to the sequence number.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
246
service-list mdns-sd
To Next Page
Loading...
Need help?
General
