Cisco Catalyst 3650 Series User Manual

show interfaces private-vlan mapping
To display private VLAN mapping information for the VLAN switch virtual interfaces (SVIs), use the show
interfaces private-vlan mapping command in user EXEC or privileged EXEC mode.
show interfaces [interface-id] private-vlan mapping
Syntax Description
(Optional) ID of the interface for which to display private VLAN mapping
information.
interface-id
Command Default
None
Command Modes
User EXEC
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Examples
This example shows how to display the information about the private VLAN mapping:
Device#show interfaces private-vlan mapping
Interface Secondary VLAN Type
--------- -------------- -----------------
vlan2 301 community
vlan3 302 community
Related Commands
DescriptionCommand
Creates a mapping between the primary and the secondary VLANs so that
both VLANs share the same primary VLAN switched virtual interface (SVI).
private-vlan mapping
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
1028
show interfaces private-vlan mapping

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)