Cisco Catalyst 3650 Series User Manual

ip device tracking maximum
To configure IP device tracking parameters on a Layer 2 access port, use the ip device tracking maximum
command in interface configuration mode. To remove the maximum value, use the no form of the command.
ip device tracking maximum number
no ip device tracking maximum
Syntax Description
Number of bindings created in the IP device tracking table for a port. The range is
0 (disabled) to 65535.
number
Command Default
None
Command Modes
Interface configuration mode
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
To remove the maximum value, use the no ip device tracking maximum command.
To disable IP device tracking, use the ip device tracking maximum 0 command.
This command enables IPDT wherever its configuredNote
Examples
This example shows how to configure IP device tracking parameters on a Layer 2 access port:
Device# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Device(config)# ip device tracking
Device(config)# interface gigabitethernet1/0/3
Device(config-if)# switchport mode access
Device(config-if)# switchport access vlan 1
Device(config-if)# ip device tracking maximum 5
Device(config-if)# switchport port-security
Device(config-if)# switchport port-security maximum 5
Device(config-if)# end
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
763
ip device tracking maximum

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)