Cisco Catalyst 3650 Series - Test Mcu Read-Register

test mcu read-register
To enable debugging of the Power over Ethernet (PoE) controller, use the test mcu read-register command
in privileged EXEC mode.
test mcu read-register {det-cls-offset| manufacture-id| port-mode}
Syntax Description
Displays the read detection classification register summary.det-cls-offset
Displays the PoE controller manufacture ID.manufacture-id
Displays the port mode details.port-mode
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Examples
The following is sample output from the test mcu read-register det-cls-offset command:
Device# test mcu read-register det-cls-offset 1
DETECTION ENABLE BIT SUMMARY
Controller port1 port2 port3 port4 register
(hexadecimal)
---------- ------- ------- ------- ------- ------------
1 1 0 1 0 5
2 1 0 1 0 5
3 1 0 1 0 5
4 1 0 1 0 5
5 1 0 1 0 5
6 1 0 1 0 5
7 1 0 1 0 5
8 1 0 1 0 5
9 1 0 1 0 5
10 1 0 1 0 5
11 0 0 1 0 4
12 1 0 0 0 1
CLASSIFICATION ENABLE BIT SUMMARY
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
132
test mcu read-register