Cisco Catalyst 3650 Series

export-protocol netflow-v9
To configure NetFlow Version 9 export as the export protocol for a Flexible NetFlow exporter, use the
export-protocol netflow-v9 command in flow exporter configuration mode.
export-protocol netflow-v9
Syntax Description
This command has no arguments or keywords.
Command Default
NetFlow Version 9 is enabled.
Command Modes
Flow exporter configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
The device does not support NetFlow v5 export format, only NetFlow v9 export format is supported.
Examples
The following example configures NetFlow Version 9 export as the export protocol for a NetFlow exporter:
Device(config)# flow exporter FLOW-EXPORTER-1
Device(config-flow-exporter)# export-protocol netflow-v9
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
428
export-protocol netflow-v9