show ip pim mdt history
To display information about the history of data multicast distribution tree (MDT) groups that have been
reused, use the show ip pim mdt historycommand in privileged EXEC mode.
show ip pim vrf vrf-name mdt history interval minutes
Syntax Description
Displays the history of data MDT groups that have
been reused for the Multicast VPN (MVPN) routing
and forwarding (MVRF) instance specified for the
vrf-name argument.
vrf vrf-name
Specifies the interval (in minutes) for which to display
information about the history of data MDT groups
that have been reused. The range is from 1 to 71512
minutes (7 weeks).
interval minutes
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Denali 16.3.2
Usage Guidelines
The output of the show ip pim mdt history command displays the history of reused MDT data groups for
the interval specified with the interval keyword and minutes argument. The interval is from the past to the
present, that is, from the time specified for the minutes argument to the time at which the command is issued.
Examples
The following is sample output from the show ip pim mdt historycommand:
Device# show ip pim vrf vrf1 mdt history interval 20
MDT-data send history for VRF - vrf1 for the past 20 minutes
MDT-data group Number of reuse
10.9.9.8 3
10.9.9.9 2
The table below describes the significant fields shown in the display.
Table 20: show ip pim mdt history Field Descriptions
DescriptionField
The MDT data group for which information is being
shown.
MDT-data group
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
396
show ip pim mdt history
To Next Page
Loading...
Need help?
General
