Cisco Catalyst 3650 Series - Command Reference, Cisco IOS XE Everest 16.5.1 A (Catalyst 3650 Switches

Usage Guidelines
Use the show env EXEC command to display the information for the switch being accessed—a standalone
switch or the active switch. Use this command with the stack and switch keywords to display all information
for the stack or for the specified stack member.
If you enter the show env temperature status command, the command output shows the switch temperature
state and the threshold level.
You can also use the show env temperature command to display the switch temperature status. The command
output shows the green and yellow states as OK and the red state as FAULTY. If you enter the show env all
command, the command output is the same as the show env temperature status command output.
Examples
This is an example of output from the show env all command:
Device>show env all
Switch 1 FAN 1 is OK
Switch 1 FAN 2 is OK
Switch 1 FAN 3 is OK
FAN PS-1 is NOT PRESENT
FAN PS-2 is OK
Switch 1: SYSTEM TEMPERATURE is OK
SW PID Serial# Status Sys Pwr PoE Pwr Watts
-- ------------------ ---------- --------------- ------- ------- -----
1A Not Present
1B PWR-C1-715WAC LIT150119Z1 OK Good Good 715
Device>show env all
Switch 1 FAN 1 is OK
Switch 1 FAN 2 is OK
Switch 1 FAN 3 is OK
FAN PS-1 is OK
FAN PS-2 is NOT PRESENT
Switch 1: SYSTEM TEMPERATURE is OK
SW PID Serial# Status Sys Pwr PoE Pwr Watts
-- ------------------ ---------- --------------- ------- ------- -----
1A PWR-C2-250WAC LIT16372A1M OK Good Good 250
1B Not Present
This is an example of output from the show env fan command:
Device>show env fan
Switch 1 FAN 1 is OK
Switch 1 FAN 2 is OK
Switch 1 FAN 3 is OK
FAN PS-1 is NOT PRESENT
FAN PS-2 is OK
This is an example of output from the show env power command:
Device>show env power
SW PID Serial# Status Sys Pwr PoE Pwr Watts
-- ------------------ ---------- --------------- ------- ------- -----
1A Not Present
1B PWR-C1-715WAC LIT150119Z1 OK Good Good 715
This is an example of output from the show env power all command on the active switch:
Device# show env power all
SW PID Serial# Status Sys Pwr PoE Pwr Watts
-- ------------------ ---------- --------------- ------- ------- -----
1A Not Present
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
71
show env