Cisco Catalyst 3650 Series

sdm prefer
To specify the SDM template for use on the switch, use the sdm prefer command in global configuration
mode.
sdm prefer {advanced}
Syntax Description
Supports advanced features such as NetFlow.advanced
Command Default
No default behavior or values.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
In a device stack, all stack members must use the same SDM template that is stored on the active device.
When a new device is added to a stack, the SDM configuration that is stored on the active device overrides
the template configured on an individual device.
Examples
This example shows how to configure the advanced template:
Device(config)# sdm prefer advanced
Device(config)# exit
Device# reload
Related Commands
DescriptionCommand
Displays the SDM template in use.
show sdm prefer
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
939
sdm prefer