Cisco Catalyst 3650 Series User Manual

bfd template
To bind a single hop Bidirectional Forwarding Detection (BFD) template to an interface, use the bfd template
command in interface configuration mode. To unbind single-hop BFD template from an interface, use the no
form of this command
bfd template template-name
no bfd template template-name
Command Default
A BFD template is not bound to an interface.
Command Modes
Interface configuration (config-if)
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Denali 16.3.1
Usage Guidelines
Even if you have not created the template by using the bfd-template command, you can configure the name
of the template under an interface, but the template is considered invalid until you define the template. You
do not have to reconfigure the template name again. It becomes valid automatically.
Examples
Device> enable
Device# configuration terminal
Device(config)# interface Gigabitethernet 1/3/0
Device(config-if)# bfd template template1
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
693
bfd template

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)