Cisco Catalyst 3650 Series User Manual

boot manual
To configure manual boot, use the boot manual command in global configuration mode. To remove the
configuration, use the no form of this command.
boot manual switch switch-number
no boot manual switch switch-number
Syntax Description
Configures manual boot for the switches in the stack.
switch swtich-number
Command Default
Manual boot is enabled.
Command Modes
Global configuration (config)
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Denali 16.3.2
Usage Guidelines
When manual boot is disabled, and the switch reloads, the boot process starts automatically. When manual
boot is disabled, the bootloader determines whether to execute a device boot or a network boot based on the
configured value of the iPXE ROMMON variable.
Examples
The following example shows how to configure manual boot for switch 2:
Device(config)# boot manual switch 2
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
573
boot manual

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)