show vtp
To display general information about the VLAN Trunking Protocol (VTP) management domain, status, and
counters, use the show vtp command in EXEC mode.
show vtp {counters| devices [conflicts]| interface [interface-id]| password| status}
Syntax Description
Displays the VTP statistics for the device.counters
Displays information about all VTP version 3 devices in the domain. This
keyword applies only if the device is not running VTP version 3.
devices
(Optional) Displays information about VTP version 3 devices that have
conflicting primary servers. This command is ignored when the device is
in VTP transparent or VTP off mode.
conflicts
Displays VTP status and configuration for all interfaces or the specified
interface.
interface
(Optional) Interface for which to display VTP status and configuration.
This can be a physical interface or a port channel.
interface-id
Displays the configured VTP password (available in privileged EXEC
mode only).
password
Displays general information about the VTP management domain status.status
Command Default
None
Command Modes
User EXEC
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
When you enter the show vtp password command when the device is running VTP version 3, the display
follows these rules:
•
If the password password global configuration command did not specify the hidden keyword and
encryption is not enabled on the device, the password appears in clear text.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
1039
show vtp
To Next Page
Loading...
Need help?
General
