EasyManuals Logo

Cisco Catalyst 3650 Series User Manual

Cisco Catalyst 3650 Series
1108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #781 background imageLoading...
Page #781 background image
Configures the interval, in seconds, between two successive
EAPOL-Start frames when they are being retransmitted.
The range is from 1 to 65535. The default is 30.
In Cisco IOS Release 15.2(5)E, this command is only available in
the supplicant mode. If the command is applied in any other mode,
the command misses from the configuration.
start-period seconds
Sets the authenticator-to-supplicant retransmission time for all EAP
messages other than EAP Request ID.
The range is from 1 to 65535. The default is 30.
supp-timeout seconds
Configures the number of seconds between retransmission of EAP
request ID packets (assuming that no response is received) to the
client.
The range is from 1 to 65535. The default is 30.
If an 802.1X packet is sent to the supplicant and the supplicant
does not send a response after the retry period, the packet will
be sent again.
tx-period seconds
Command Default
Periodic reauthentication and periodic rate-limiting are done.
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
You should change the default value of this command only to adjust for unusual circumstances such as
unreliable links or specific behavioral problems with certain clients and authentication servers.
The dot1x timeout reauth-period interface configuration command affects the behavior of the switch only
if you have enabled periodic re-authentication by using the dot1x reauthentication interface configuration
command.
During the quiet period, the switch does not accept or initiate any authentication requests. If you want to
provide a faster response time to the user, enter a number smaller than the default.
When the ratelimit-period is set to 0 (the default), the switch does not ignore EAPOL packets from clients
that have been successfully authenticated and forwards them to the RADIUS server.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
755
dot1x timeout

Table of Contents

Other manuals for Cisco Catalyst 3650 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3650 Series and is the answer not in the manual?

Cisco Catalyst 3650 Series Specifications

General IconGeneral
RAM4 GB
Flash Memory4 GB
Ports24 or 48 10/100/1000 Ethernet ports
Uplinks4 x 1G SFP or 4 x 10G SFP+ (depending on model)
StackingUp to 9 switches with StackWise-160
Layer SupportLayer 2, Layer 3
SoftwareCisco IOS Software
Power SupplyInternal power supply; optional redundant power supply available
Storage Temperature-40°F to 158°F (-40°C to 70°C)

Related product manuals