Cisco Catalyst 3650 Series User Manual

dscp
To configure a differentiated services code point (DSCP) value for flow exporter datagrams, use the dscp
command in flow exporter configuration mode. To remove a DSCP value for flow exporter datagrams, use
the no form of this command.
dscp dscp
no dscp dscp
Syntax Description
DSCP to be used in the DSCP field in exported datagrams. The range is 0 to 63. The
default is 0.
dscp
Command Default
The differentiated services code point (DSCP) value is 0.
Command Modes
Flow exporter configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
To return this command to its default setting, use the no dscp or default dscp flow exporter configuration
command.
Examples
The following example sets 22 as the value of the DSCP field in exported datagrams:
Device(config)# flow exporter FLOW-EXPORTER-1
Device(config-flow-exporter)# dscp 22
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
427
dscp

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)