Cisco Catalyst 3650 Series User Manual

switch priority
To change the stack member priority value, use the switch priority command in EXEC mode on the active
switch.
switch stack-member-number priority new-priority-value
Syntax Description
Current stack member number. The range is 1 to 9.
stack-member-number
New stack member priority value. The range is 1 to 15.
new-priority-value
Command Default
The default priority value is 1.
Command Modes
User EXEC
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
The new priority value is a factor when a new active switch is elected. When you change the priority value
the active switch is not changed immediately.
Examples
This example shows how to change the priority value of stack member 6 to 8:
Device# switch 6 priority 8
Changing the Switch Priority of Switch Number 6 to 8
Do you want to continue?[confirm]
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
881
switch priority

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)