Cisco Catalyst 3650 Series User Manual

vrrp priority
To set the priority level of the device within a Virtual Router Redundancy Protocol (VRRP) group, use the
priority command in interface configuration mode. To remove the priority level of the device, use the no
form of this command.
priority level
no priority level
Syntax Description
Priority of the device within the VRRP group. The
range is from 1 to 254. The default is 100.
level
Command Default
The priority level is set to the default value of 100.
Command Modes
VRRP configuration (config-if-vrrp)
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Release 2.1
Usage Guidelines
Use this command to control which device becomes the master virtual router.
Examples
The following example configures the device with a priority of 254:
Device(config-if-vrrp)# priority 254
Related Commands
DescriptionCommand
Creates a VRRPv3 group and enters VRRPv3 group
configuration mode.
vrrp
Configures the device to take over as master virtual
router for a VRRP group if it has higher priority than
the current master virtual router.
vrrp preempt
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
205
vrrp priority

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)