Cisco Catalyst 3650 Series User Manual

show errdisable detect
To display error-disabled detection status, use the show errdisable detect command in EXEC mode.
show errdisable detect
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
User EXEC
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
A gbic-invalid error reason refers to an invalid small form-factor pluggable (SFP) module.
The error-disable reasons in the command output are listed in alphabetical order. The mode column shows
how error-disable is configured for each feature.
You can configure error-disabled detection in these modes:
• port mode—The entire physical port is error-disabled if a violation occurs.
• vlan mode—The VLAN is error-disabled if a violation occurs.
• port/vlan mode—The entire physical port is error-disabled on some ports and is per-VLAN error-disabled
on other ports.
Examples
This is an example of output from the show errdisable detect command:
Device> show errdisable detect
ErrDisable Reason Detection Mode
----------------- --------- ----
arp-inspection Enabled port
bpduguard Enabled vlan
channel-misconfig Enabled port
community-limit Enabled port
dhcp-rate-limit Enabled port
dtp-flap Enabled port
gbic-invalid Enabled port
inline-power Enabled port
invalid-policy Enabled port
l2ptguard Enabled port
link-flap Enabled port
loopback Enabled port
lsgroup Enabled port
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
73
show errdisable detect

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)