Cisco Catalyst 3650 Series

Examples
This example shows how to configure the LACP port priority on a port:
Device# interface gigabitethernet2/0/1
Device(config-if)# lacp port-priority 1000
You can verify your settings by entering the show lacp [channel-group-number] internal privileged EXEC
command.
Related Commands
DescriptionCommand
Assigns an Ethernet port to an EtherChannel group, or enables an
EtherChannel mode, or both.
channel-group
Configures the LACP system priority.
lacp system-priority
Displays LACP channel-group information.
show lacp
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
310
lacp port-priority