Cisco Catalyst 3650 Series

switchport mode access
To sets the interface as a nontrunking nontagged single-VLAN Ethernet interface , use the switchport mode
access command in template configuration mode. Use the no form of this command to return to the default
setting.
switchport mode access
no switchport mode access
Syntax Description
Sets the interface as a nontrunking nontagged single-VLAN Ethernet
interface.
switchport mode access
Command Default
An access port can carry traffic in one VLAN only. By default, an access port carries traffic for VLAN1.
Command Modes
Template configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Examples
This example shows how to set a single-VLAN interface
Device(config-template)# switchport mode access
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
567
switchport mode access