Cisco Catalyst 3650 Series

Configured pairwise ciphers:
gcm-encrypt
null
Replay protection: enabled
Replay protection mode: STRICT
Selected cipher:
Propagate SGT: Enabled
Cache Info:
Cache applied to link : NONE
Statistics:
authc success: 0
authc reject: 0
authc failure: 0
authc no response: 0
authc logoff: 0
sap success: 0
sap fail: 0
authz success: 0
authz fail: 0
port auth fail: 0
Ingress:
control frame bypassed: 0
sap frame bypassed: 0
esp packets: 0
unknown sa: 0
invalid sa: 0
inverse binding failed: 0
auth failed: 0
replay error: 0
Egress:
control frame bypassed: 0
esp packets: 0
sgt filtered: 0
sap frame bypassed: 0
unknown sa dropped: 0
unknown sa bypassed: 0
The following example displays output using the brief keyword:
Device# show cts interface brief
Global Dot1x feature is Disabled
Interface GigabitEthernet0/1/0:
CTS is enabled, mode: MANUAL
IFC state: OPEN
Interface Active for 00:00:40.386
Authentication Status: NOT APPLICABLE
Peer identity: "unknown"
Peer's advertised capabilities: ""
Authorization Status: NOT APPLICABLE
SAP Status: NOT APPLICABLE
Propagate SGT: Enabled
Cache Info:
Cache applied to link : NONE
Related Commands
DescriptionCommand
Enables an interface for CTS.cts manual
Enables Security Group Tag (SGT) propagation at
Layer 2 on Cisco TrustSec Security (CTS) interfaces.
propagate sgt (cts manual)
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
809
show cts interface