service-policy (Wired)
To apply a policy map to a physical port or a switch virtual interface (SVI), use the service-policy command
in interface configuration mode. Use the no form of this command to remove the policy map and port
association.
service-policy {input | output} policy-map-name
no service-policy {input | output} policy-map-name
Syntax Description
Apply the specified policy map to the input of a physical port or an
SVI.
input policy-map-name
Apply the specified policy map to the output of a physical port or
an SVI.
output policy-map-name
Command Default
No policy maps are attached to the port.
Command Modes
WLAN interface configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
A policy map is defined by the policy map command.
Only one policy map is supported per port, per direction. In other words, only one input policy and one output
policy is allowed on any one port.
You can apply a policy map to incoming traffic on a physical port or on an SVI. QoS Configuration Guide
(Catalyst 3650 Switches).
Though visible in the command-line help strings, the history keyword is not supported, and you should
ignore the statistics that it gathers.
Note
Examples
This example shows how to apply plcmap1 to an physical ingress port:
Device(config)# interface gigabitethernet2/0/1
Device(config-if)# service-policy input plcmap1
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
660
service-policy (Wired)
To Next Page
Loading...
Need help?
General
