Cisco Catalyst 3650 Series User Manual

show ip igmp filter
To display Internet Group Management Protocol (IGMP) filter information, use the show ip igmp filter
command in privileged EXEC command mode.
show ip igmp [vrf vrf-name] filter
Syntax Description
(Optional) Supports the multicast VPN routing and forwarding (VRF)
instance.
vrf vrf-name
Command Default
IGMP filters are enabled by default.
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
The show ip igmp filter command displays information about all filters defined on the device.
Examples
The following is sample output from the show ip igmp filter command:
Device# show ip igmp filter
IGMP filter enabled
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
251
show ip igmp filter

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)