auto qos trust
To automatically configure quality of service (QoS) for trusted interfaces within a QoS domain, use the auto
qos trust command in interface configuration mode. To return to the default setting, use the no form of this
command.
auto qos trust {cos| dscp}
no auto qos trust {cos| dscp}
Syntax Description
Trusts the CoS packet classification.cos
Trusts the DSCP packet classification.dscp
Command Default
Auto-QoS trust is disabled on the port.
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Use this command to configure the QoS for trusted interfaces within the QoS domain. The QoS domain
includes the device, the network interior, and edge devices that can classify incoming traffic for QoS. When
auto-QoS is enabled, it uses the ingress packet label to categorize traffic, to assign packet labels, and to
configure the ingress and egress queues.
Table 30: Traffic Types, Packet Labels, and Queues
All Other TrafficReal-Time
Video Traffic
STP
3
BPDU
4
Traffic
Routing
Protocol
Traffic
VOIP
Control
Traffic
VOIP Data
Traffic
–
34564824, 2646DSCP
5
–
37635CoS
6
0, 1
(queue 4)
2 (queue
3)
0 (queue 3)2, 3, 6, 7 (queue 2)4, 5
(queue 1)
CoS-to-egress
queue map
3
STP = Spanning Tree Protocol
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
608
auto qos trust
To Next Page
Loading...
Need help?
General
