Cisco Catalyst 3650 Series User Manual

source (ERSPAN)
To configure the Encapsulated Remote Switched Port Analyzer (ERSPAN) source interface or VLAN, and
the traffic direction to be monitored, use the source command in ERSPAN monitor source session configuration
mode. To disable the configuration, use the no form of this command.
source {interface type number | vlan vlan-ID}[, | - | both | rx | tx]
Syntax Description
Specifies an interface type and number.
interface type number
Associates the ERSPAN source session number with VLANs. Valid values
are from 1 to 4094.
vlan vlan-ID
(Optional) Specifies another interface.,
(Optional) Specifies a range of interfaces.-
(Optional) Monitors both received and transmitted ERSPAN traffic.both
(Optional) Monitors only received traffic.rx
(Optional) Monitors only transmitted traffic.tx
Command Default
Source interface or VLAN is not configured.
Command Modes
ERSPAN monitor source session configuration mode (config-mon-erspan-src)
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Denali 16.3.1
Usage Guidelines
You cannot include source VLANs and filter VLANs in the same session.
Examples
The following example shows how to configure ERSPAN source session properties:
Switch(config)# monitor session 2 type erspan-source
Switch(config-mon-erspan-src)# source interface fastethernet 0/1 rx
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
565
source (ERSPAN)

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)