show interfaces switchport
To display the administrative and operational status of a switching (nonrouting) port, including port blocking
and port protection settings, use the show interfaces switchport command in privileged EXEC mode.
show interfaces [interface-id] switchport [module number]
Syntax Description
(Optional) ID of the interface. Valid interfaces include physical ports (including
type, stack member for stacking-capable switches, module, and port number) and
port channels. The port channel range is 1 to 48.
interface-id
(Optional) Displays switchport configuration of all interfaces on the switch or
specified stack member.
This option is not available if you entered a specific interface ID.
module number
Command Default
None
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
Use the show interface switchport module number command to display the switch port characteristics of
all interfaces on that switch in the stack. If there is no switch with that module number in the stack, there is
no output.
Examples
This is an example of output from the show interfaces switchport command for a port. The table that follows
describes the fields in the display.
Private VLANs are not supported in this release, so those fields are not applicable.Note
Device# show interfaces gigabitethernet1/0/1 switchport
Name: Gi1/0/1
Switchport: Enabled
Administrative Mode: trunk
Operational Mode: down
Administrative Trunking Encapsulation: dot1q
Negotiation of Trunking: On
Access Mode VLAN: 1 (default)
Trunking Native Mode VLAN: 10 (VLAN0010)
Administrative Native VLAN tagging: enabled
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
83
show interfaces switchport
To Next Page
Loading...
Need help?
General
