Cisco Catalyst 3650 Series User Manual

show platform etherchannel
To display platform-dependent EtherChannel information, use the show platform etherchannel command
in privileged EXEC mode.
show platform etherchannel channel-group-number {group-mask| load-balance mac src-mac dst-mac [ip
src-ip dst-ip [port src-port dst-port]]} [switch switch-number]
Syntax Description
Channel group number. The range is 1 to 128.
channel-group-number
Displays EtherChannel group mask.group-mask
Tests EtherChannel load-balance hash algorithm.load-balance
Specifies the source and destination MAC addresses.
mac src-mac dst-mac
(Optional) Specifies the source and destination IP addresses.
ip src-ip dst-ip
(Optional) Specifies the source and destination layer port numbers.
port src-port dst-port
(Optional) Specifies the stack member.
switch switch-number
Command Default
None
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Use this command only when you are working directly with a technical support representative while
troubleshooting a problem.
Do not use this command unless a technical support representative asks you to do so.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
347
show platform etherchannel

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)