Cisco Catalyst 3650 Series User Manual

vtp (interface configuration)
To enable the VLAN Trunking Protocol (VTP) on a per-port basis, use the vtp command in interface
configuration mode. To disable VTP on the interface, use the no form of this command.
vtp
no vtp
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Enter this command only on interfaces that are in trunking mode.
This command is supported only when the device is running VTP Version 3.
Examples
This example shows how to enable VTP on an interface:
Device(config-if)# vtp
This example shows how to disable VTP on an interface:
Device(config-if)# no vtp
Related Commands
DescriptionCommand
Configures the trunk characteristics when an interface is in trunking
mode.
switchport trunk
Globally configures VTP domain name, password, pruning, version,
and mode.
vtp (global configuration)
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
1071
vtp (interface configuration)

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)