Cisco Catalyst 3650 Series User Manual

vrrp description
To assign a description to the Virtual Router Redundancy Protocol (VRRP) group, use the vrrp description
command in interface configuration mode. To remove the description, use the no form of this command.
description text
no description
Syntax Description
Text (up to 80 characters) that describes the purpose
or use of the group.
text
Command Default
There is no description of the VRRP group.
Command Modes
VRRP configuration (config-if-vrrp)
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Release 2.1
Examples
The following example enables VRRP. VRRP group 1 is described as Building A – Marketing and
Administration.
Device(config-if-vrrp)# description Building A - Marketing and Administration
Related Commands
DescriptionCommand
Creates a VRRPv3 group and enters VRRPv3 group
configuration mode.
vrrp
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
202
vrrp description

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)