show pagp
To display Port Aggregation Protocol (PAgP) channel-group information, use the show pagp command in
EXEC mode.
show pagp [channel-group-number] {counters| dual-active| internal| neighbor}
Syntax Description
(Optional) Channel group number. The range is 1 to 128.
channel-group-number
Displays traffic information.counters
Displays the dual-active status.dual-active
Displays internal information.internal
Displays neighbor information.neighbor
Command Default
None
Command Modes
User EXEC
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
You can enter any show pagp command to display the active channel-group information. To display the
nonactive information, enter the show pagp command with a channel-group number.
Examples
This is an example of output from the show pagp 1 counters command:
Device> show pagp 1 counters
Information Flush
Port Sent Recv Sent Recv
----------------------------------------
Channel group: 1
Gi1/0/1 45 42 0 0
Gi1/0/2 45 41 0 0
This is an example of output from the show pagp dual-active command:
Device> show pagp dual-active
PAgP dual-active detection enabled: Yes
PAgP dual-active version: 1.1
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
345
show pagp
To Next Page
Loading...
Need help?
General
