stack-power
To configure StackPower parameters for the power stack or for a switch in the power stack, use the stack
power command in global configuration mode. To return to the default setting, use the no form of the command,
stack-power {stack power-stack-name| switch stack-member-number}
no stack-power {stack power-stack-name| switch stack-member-number}
Syntax Description
Specifies the name of the power stack. The name can be up to 31 characters.
Entering these keywords followed by a carriage return enters power stack
configuration mode.
stack power-stack-name
Specifies the switch number in the stack (1 to 4) to enter switch stack-power
configuration mode for the switch.
switch stack-member-number
Command Default
There is no default.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
When you enter the stack-power stack power stack name command, you enter power stack configuration
mode, and these commands are available:
• default—Returns a command to its default setting.
• exit—Exits ARP access-list configuration mode.
• mode—Sets the power mode for the power stack. See the mode command.
• no—Negates a command or returns to default settings.
If you enter the stack-power switch switch-number command with a switch number that is not participating
in StackPower, you receive an error message.
When you enter the stack-power switch switch-number command with the number of a switch participating
in StackPower, you enter switch stack power configuration mode, and these commands are available:
• default—Returns a command to its default setting.
• exit—Exits switch stack power configuration mode.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
128
stack-power
To Next Page
Loading...
Need help?
General
