Cisco Catalyst 3650 Series User Manual

record
To add a flow record for a Flexible NetFlow flow monitor, use the record command in flow monitor
configuration mode. To remove a flow record for a Flexible NetFlow flow monitor, use the no form of this
command.
record record-name
no record
Syntax Description
Name of a user-defined flow record that was previously configured.
record-name
Command Default
A flow record is not configured.
Command Modes
Flow monitor configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
Each flow monitor requires a record to define the contents and layout of its cache entries. The flow monitor
can use one of the wide range of predefined record formats, or advanced users may create their own record
formats.
You must use the no ip flow monitor command to remove a flow monitor from all of the interfaces to
which you have applied it before you can modify the parameters for the record command for the flow
monitor.
Note
Examples
The following example configures the flow monitor to use FLOW-RECORD-1:
Device(config)# flow monitor FLOW-MONITOR-1
Device(config-flow-monitor)# record FLOW-RECORD-1
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
460
record

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)