match flow cts
To configure CTS source group tag and destination group tag for a flow record, use thematch flow cts
command in flow record configuration mode. To disable the group tag as key field for a flow record, use the
no form of this command.
match flow cts {source| destination} group-tag
no match flow cts {source| destination} group-tag
Syntax Description
Configures the CTS destination field group as a key field.cts destination group-tag
Configures the CTS source field group as a key field.cts source group-tag
Command Default
The CTS destination or source field group, flow direction and the flow sampler ID are not configured as key
fields.
Command Modes
Flexible NetFlow flow record configuration (config-flow-record)
Policy inline configuration (config-if-policy-inline)
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.7.3E
This command was reintroduced.
This command was not supported
in Cisco IOS XE Denali 16.1.x
Cisco IOS XE Denali 16.2.1
Usage Guidelines
A flow record requires at least one key field before it can be used in a flow monitor. The key fields distinguish
flows, with each flow having a unique set of values for the key fields. The key fields are defined using the
match command.
Examples
The following example configures the source group-tag as a key field:
Device(config)# flow record FLOW-RECORD-1
Device(config-flow-record)# match flow cts source group-tag
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
443
match flow cts
To Next Page
Loading...
Need help?
General
